PDA

View Full Version : BeastX FBL System


Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 [41] 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139

  1. Reset Beastx
  2. do ye all leave stickdeadband at factory setting ,par -E-RED FLASHING
  3. Pitch all over the place
  4. Beastx setup Orange Satellite Rx
  5. Standard gyro vs stand-alone
  6. Configuring MB with Flybar Rotorhead
  7. Quick question. Is ar7000 a standard or spektrum Sat in the setup?
  8. usb stick
  9. New setup, aileron/pitch goes opposite way.
  10. Tail endpoints + gain problem
  11. normal for the tail servo to move very little on bench?
  12. beastX in FFF compared to vbar
  13. Step J & L Discussion.
  14. anyone setup a the MB on a trex 500 w/ KDE headblock?
  15. Question about Setup point K
  16. Do I need to set it up again
  17. is dsmx workin yet??
  18. Throttle-cut on trex 600 with DX7?
  19. 6 degrees and the blue light
  20. cant figure it out
  21. 6 degrees of cyclic pitch why?
  22. I'm Stuck in Setup I
  23. end points, d/r, expo and factory settings
  24. Piro Speed
  25. Hot DS620 with Beastx