PDA

View Full Version : Align T-Rex 600 Nitro Helicopters


Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 [90] 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114

  1. Header Tank vrs Fuel Pressure?
  2. Going to run a 600 Nitro and plan on using a DX6i
  3. Running 2 VR Spektrum Dual output Regs?
  4. Tictocs
  5. Just for fun
  6. What is the key item to watch in intalling a Header Tank
  7. low smoke fuel = less lubrication?
  8. bottom bearing block--metal?
  9. T REX 600 Gasser !!!!!!!!!!!!!!!!!!!!!!!!
  10. Trex 600 nitro
  11. 600NSP middle bearing block installation
  12. OS 50 dripping fuel from muffler while idle. Normal?
  13. Futaba GY611 on the 600N
  14. trex 600 pro n
  15. *
  16. Make sure your canopy is not too close to the on/off switch plate
  17. FAULTY ALIGN 2 in 1's!!!!!!!!!!!!
  18. 600NSP metal upgrade question
  19. Share your lucky escapes...
  20. Ace ds 1015's.........at 7-8 volts?????
  21. YS .50 or Redline TT53H
  22. Tail Shudder - Nose Down Funnels
  23. engines and loctite?
  24. cross threaded OS 50 hyper whilst installing G/plug
  25. cross threaded OS 50 hyper whilst installing G/plug