Bradley Jones
10-28-2008, 05:15 PM
I replaced the blades, and two sets of servo gears. One set of gears was the lower servo if you are looking at the "driver side" of the heli (there are two servos stacked) the other set of gears I replaced was I believe the servo that controls the pitch :thinking its the servo that is under where the battery velcros on. Well everything is back together and I'm pretty good with tickering on stuff such as that BUT, the Heli blades don't spin straight. They would lean too much to the left so I adjusted the linkage rods and then too much to the right :arggg: I finally got it decent and then they lean too much front or back!!! I'm new to this and I regret going big and buying a blade 400 right off the bat, but hell, I guess thats half the fun :YeaBaby: . Does anyone have any info for me, the manual is very vague and the video section on this forum don't seem to work on my Mac. By the way I never messed with anything except the position of the linkage rod on the lower servo and the elevator servo arm on the front servo. I had to take those off to swap out the gears so I'm assuming thats whats out of wack now. Thanks in advance guys
Bradley J.
Bradley J.