rplumbo
03-05-2006, 01:20 PM
Posted @ RR too...
Here are the parts from my Fury Extreme as I have now upgraded to a Stratus. There are the regular Fury to Stratus leftovers, plus many extra parts. $140 takes the lot.
PayPal only on this one, but I’m not charging the extra 3%.
Extreme to Stratus Leftovers
-Left & right frame
-Vertical channel with rear with bearing
-Baseplate
-Landing gear mounts
-Switch mount
-Battery tray and forward channel
-8.18 plates cut for the HD clutch
-8.18 Motor mount & shims
-Carbon pushrod (connects servo to tail bellcrank)
-Extreme flybar carrier (2 #0307 arms and seesaw with balls and bearings)
In addition to the conversion parts, you'll also get:
(2) 115-02 front channels (1 new in package, 1 flown)
(1) 0307 flybar arm new in package
(3) 115-10 rear channels with bearings (1 flown, 2 new in package)
(2) 115-40 landing gear mounts (1 new in package, 1 flown)
(1) 8.18 motor mount, this is the 2 side pieces, plus the center piece
(5) Fan shroud mounts
(1) G-10 base plate
(1) Painted horizontal fin
(1) Fuel tank (uncut, no hardware)
A LOT of hardware (screws, nuts etc.)
The left frame has a very small crack where the clutch bearing block sits. It has been repaired with CA and, as far as I have seen, does not affect flight performance. The price of this lot reflects this.
I will not separate yet.
$140 shipped to your door via USPS Priority mail.
Thanks!
Reid
Here are the parts from my Fury Extreme as I have now upgraded to a Stratus. There are the regular Fury to Stratus leftovers, plus many extra parts. $140 takes the lot.
PayPal only on this one, but I’m not charging the extra 3%.
Extreme to Stratus Leftovers
-Left & right frame
-Vertical channel with rear with bearing
-Baseplate
-Landing gear mounts
-Switch mount
-Battery tray and forward channel
-8.18 plates cut for the HD clutch
-8.18 Motor mount & shims
-Carbon pushrod (connects servo to tail bellcrank)
-Extreme flybar carrier (2 #0307 arms and seesaw with balls and bearings)
In addition to the conversion parts, you'll also get:
(2) 115-02 front channels (1 new in package, 1 flown)
(1) 0307 flybar arm new in package
(3) 115-10 rear channels with bearings (1 flown, 2 new in package)
(2) 115-40 landing gear mounts (1 new in package, 1 flown)
(1) 8.18 motor mount, this is the 2 side pieces, plus the center piece
(5) Fan shroud mounts
(1) G-10 base plate
(1) Painted horizontal fin
(1) Fuel tank (uncut, no hardware)
A LOT of hardware (screws, nuts etc.)
The left frame has a very small crack where the clutch bearing block sits. It has been repaired with CA and, as far as I have seen, does not affect flight performance. The price of this lot reflects this.
I will not separate yet.
$140 shipped to your door via USPS Priority mail.
Thanks!
Reid