JR 500T Gyro Question

[wayder]

Hello Freaks,

Need a little help on figuring out where the gray wire goes in the white connector on the gyro. The connector fell on the floor when I had the wire out to slide the heat shrink on the wire and I can not remember where it actually should be placed. javascript:emoticon(':arggg:') If you place the white connector on the right and the gray wire on the left side and the little fingers that hold the wire connector in facing you, where is the gray wire? At the top or at the bottom?

Thank you for your help,

Wayne...

[bigrcr]

The Grey wire goes into the "signal" position of the white connector. This would be the orange wire in the JR type connector or the white wire on the Futaba connector.

From your explanation, the Grey wire would go on the far left when observing the clips on the connector. To be sure, match the wires on your connector and put the Grey wire in the "orange wire" or "left" position.

Hope this helps!!!

[wayder]

Thanks John!

Wayne