PDA

View Full Version : Carb throttle setup after front to rear setup?


RC_Feen
11-11-2008, 01:34 AM
I just changed the engine setup from front to rear facing. In setting up the throttle linkage where should the ball link be? On the inside closer to the engine or torwards the outside near the air clearner? I tried to follow the Finless vid's but just need some better visuals/pictures of current setups. Currently I have throttle valve setup with the ball on the carb torwards the outside near the air filter. I'll take some pictures later this evening. Thanks!

geepfreek
11-11-2008, 05:50 PM
towards the engine

rbort
11-11-2008, 10:57 PM
And drill a second hole in the arm closer to the pivot point and move it away from the engine some more otherwise the throttle pushrod can rub against the fan shroud.

-=>Raja.

RC_Feen
11-12-2008, 12:11 PM
I watched the part 2 Spectra build video again and got it figured out. Now I have to get the receiver installed and start setup. Thanks for the info guys!:thumbup: