9303 lever?

[main rotrz]

i just picked up a jr 9303 and wanted to know what the lever on the side of the radio is for ,i looked through the manual and didnt read anything about it

[widower]

It can be used to adjust throttle and pitch offsets, or it can be a separate channel.

[DominicD]

I highly suggest disabling it before starting your setup.

[HoffY]

From when i got mine they have always got in the way. When setting up they are bumped and it screws everything up (as mid stick isnt mid stick if both levers arent central). I have managed to disable teh right side one. But i can't figure out how to disable the left side one. Any takers? The damn thing still has an effect even when i have INH both AUX3&4 yet the right side one seems to be disabled.

[DominicD]

Go into Del DeviceSEl and INH Pit. TRIM

[main rotrz]

thanks guys i could not find anything in the book

[Scotty T]

Wait a minute, I've never noticed any problems but I'm going to re-check it.

If I move these around the whole pitch is going to change or the pitch servo only?

I'm curioius now.

[Pinecone]

If in CCPM, the whole pitch will change, more at mid stick, less at near the ends.

If in 1 servo mode (mechanical mixing) only the pitch servo will move, but the same results.

[Scotty T]

Thanks for the info, like I said I've never noticed a problem, but I'm going to look into that.

[dondrake]

I use the left lever for switchglow and the right i use to adjust helicommand rigid.

by default they are inhibited. think pinecone said it right go int device sel and you can inhibit or enable , then change functions for each if you want later