gv1 and 149 pcm recivers

[roy voss]

i am having problems setting up my gv1 with 149 pcm receiver with my 14mz. i can get it to switch on and off, off when hold is pulled. speed section work. i just am not able to adjust rpm from the transmitter. i believe it can be done , just can not get it to work . any help would be great full, i tried eric larson instructions and i am still can not get it to work, not sure what i am doing wrong.

roy

[RCfan]

You probably should start out by describing how you've setup all the connections, e.g. governor to Rx. I assume you've correctly assigned a governor function on the 14MZ, gone into the governor menu screen and performed the speed calibration (right side buttons on the gov screen), correct?

On the GV1, you've properly assigned IDLE, HIGH and STOP throttle positions and configured it to turn itself on via aux channel. Better yet, why don't you list all the settings on your GV1.

[roy voss]

sorry i should have put that info in last night, i was tired and it was late. i am at work now and will try to post it later at lunch. do not remember everthing off the top of my head.

[rkeith2]

Conditions are important as well to make sure the GV1 disengages when you hit hold -

I usually employ the STSW so that throttle coming down towards 1/4 stick will also turn off the GV1 unless you are in and idle up condition.

[roy voss]

after good night sleep and a little thought. was able to get it work right. had to null one of the swichts.
roy