How fast pirouettes 600n?

[madmaxveria]

My 600n has a 401gyro and dx7 for tail blades i have the 103s but it still pirouettes slow.Does anyone knows anything about that?:arggg:

Merry Christmas from Greece.

[Grant_beltcp]

Increase your rudder end points/ATV's

[george0079]

Increase your rudder end points/ATV's

Yep. Run them up all the way to 150% for both sides, in the DX7. That will give you the max piro rate for both directions.

If it's still too slow, then switch back to 95mm blades, and re-adjust the ATV's on the 401 to max travel (Without binding), and try it again.

[stenkilde]

The boys are right! thats the way to go. I think mine can piro over 4 times pr second or faster. Redicolous fast!

[BarracudaHockey]

If you really want it a blur, set up a mix that reduces the gyro gain as you increase the rudder input. Just make sure your battery is tied down :)

[MrCLoWnY]

Just curious, do you guys really fly with this fast of a piro rate? i ask becuz I had to tame mine down a bit as it was making it difficult to turn. But at the same time im a newbie.. Should i put it back the way it was and just learn to fly like that?

[madmaxveria]

Thank you all guy's very much and merry Christmas.

[jwilkens]

Just curious, do you guys really fly with this fast of a piro rate? i ask becuz I had to tame mine down a bit as it was making it difficult to turn. But at the same time im a newbie.. Should i put it back the way it was and just learn to fly like that?

I have mine relatively high, but I use expo on the DX7 to tame it down around centre stick to make the turns easier.

[george0079]

I have mine relatively high, but I use expo on the DX7 to tame it down around centre stick to make the turns easier.


+1

[TheBum]

I have mine relatively high, but I use expo on the DX7 to tame it down around centre stick to make the turns easier.

+2