mavrikk push pull elevator question

[Felony44]

i am using a JR DS811 servo with the round servo horn and i have the ball links at 10.5mm from the center of the horn the problem i am having is one of the two connecting rods that are set at 86mm will not reach the servo horn and since i have no instructions who knows if i have set up right. Are these the right dimensions? how should this be setup and am i using the right servo horn and ball link position? does anyone have any pictures of one setup right

[Felony44]

now i have the same problem with the aileron one of the linkages does not fit when the other linkage is connected any clue what im doing wrong??

[capebob]

The drive post position differs a little from one servo brand and type to another. You may have to adjust the rod lengths slightly to accommodate your servos. In the case of the aileron links make sure that the rods that connect to the swashplate are the proper length and adjust the rods that attach to the servo to fit. Do the same with the elevator links.

Bob

[Felony44]

Thanks should i adjust the linkage rods equally?

[capebob]

Yes.