Mikej
01-10-2009, 02:53 AM
Hi,
On Thursday I popped down to the field and flew a couple of packs through my Copterx 450 using my DX7. I came home and later flew a couple of packs on my Trex 250 (obviously changing the model in the meantime), however when I turned my DX7 on tings went a bit strange.
I turned on the Tx holding down the buttons, changed model, turned off and on, flipped on Throttle Hold and plugged the battery into my Trex 250 (all OK so far). I went outside, out the 250 on the floor, turned off TH and gave some throttle - rather than the usual smooth slow start the motor tried a couple of times to turn, but just stuttered. I took off the canopy and battery and tried again - same thing. So far I thought that I had an issue with my 250 or the battery so I went back inside and turned off the DX7 and turned it back on - the screen display was upside down !!!!!
All of the letters and pictures were inverted and the lines normally at the top were at the bottom etc. - just as if someone had flipped the screen around 180 degrees !!!. Has anyone else seen anything like this ? Should I be worried ?.
I have subsequently put a couple of batteries through (1 on the CX450 one on the T250) without any problems. Any ideas ??.
Thanks,
Mike.
On Thursday I popped down to the field and flew a couple of packs through my Copterx 450 using my DX7. I came home and later flew a couple of packs on my Trex 250 (obviously changing the model in the meantime), however when I turned my DX7 on tings went a bit strange.
I turned on the Tx holding down the buttons, changed model, turned off and on, flipped on Throttle Hold and plugged the battery into my Trex 250 (all OK so far). I went outside, out the 250 on the floor, turned off TH and gave some throttle - rather than the usual smooth slow start the motor tried a couple of times to turn, but just stuttered. I took off the canopy and battery and tried again - same thing. So far I thought that I had an issue with my 250 or the battery so I went back inside and turned off the DX7 and turned it back on - the screen display was upside down !!!!!
All of the letters and pictures were inverted and the lines normally at the top were at the bottom etc. - just as if someone had flipped the screen around 180 degrees !!!. Has anyone else seen anything like this ? Should I be worried ?.
I have subsequently put a couple of batteries through (1 on the CX450 one on the T250) without any problems. Any ideas ??.
Thanks,
Mike.