JR9X2 Need Help

[sookainian]

I would like to know whether is this normal.

First on the radio,

Then press the LIST button into FUNC. LIST,

Then go into MONITOR.

Next under THRO, put your throttle stick all the way down then press the trim button beside the throttle stick and trim it all the way down. Under THRO, the dot will move back right ?

Ok, Next when u put your throttle stick all the way up and trim it all the way up. Will the dot under THRO move up also ?

Mine wont any ideas why like that ? is this normal ?

--------------------------------------------------------------

Other way of explaining,

When i throttle stick down and trim it all the way down, my throttle servo will move back. But when i throttle stick up and trim it all the way up, my throttle servo wont move ( the linkage is not connect ) any ideas why like that ?

[Paul Hinz]

If you are saying that the throttle trim does not work when the stick is all the way up. Then that is normal most modern radios the throttle trim only works on the low throttle end of the stick travel. It makes it easier to set up full throttle on the carb with out worrying about where the trim is.

Paul

[DavidH]

On the Futaba 9Z you can choose if you want the trim to work at only Low throttle stick position. OR you can choose if you want the trim to function no matter where the throttle stick is located.

For the latter if the trim operates full throttle stick. That function will move the whole throttle curve as the trim is adjusted.

Low position setting will only adjust the throttle curve at the lowest end when the trim is moved.

David

[david.read]

Sookainian,
I have a JR 9X2 also, and it does what you say. This is quite normal.

David. :)

[sookainian]

Hey thank you guys so much.

Anyway got anyidea how do i change the switches on JR9X2 ? coz last time i am flying mode 1, but now change to mode 2. So for the last 3 months, i been flying mode 2 sticks, but mode 1 switchs.

Changing the switch do i just 'unplug' and connect it to the other side ? or i also need to reprograme it ?

[david.read]

I don't think you need to unplug any switches.

Just allocate them to the channels you want via the main menu.

Hope this helps you do what you need to do.

PS The switches never new they were flying on mode 2, so you also have the power to change then to mode 1. Or whatever. :cool:

David