PDA

View Full Version : Need MSH ball resizing tool!


copperkiid
01-15-2009, 07:40 PM
I'm got my Protos used second hand with no ball resizing tool. What is the MSH part number for the tool and where can I find one? I know the JR tool is to big. Thanks

rcmarty
01-15-2009, 08:02 PM
I haven't seen them anywhere as of yet.

-Might consider asking the guy you bought it from real nice if has it around or not.
-Put up a post looknig for one from someone who has more than 1 kit
- try asking corrado
- I did see a post one day about a cheap kit , no blades,motor,etc for about 2-225ish

good luck

Martin :)

jgoodwin
01-19-2009, 08:42 AM
In the mean time you could try a trick I did with my 450. Take an extra ball preferably with the long thread and rough it up with sandpaper, even better file a couple of grooves in it. If you can find something to both it through to give you more of a grip. I used a 450 frame stand-off. Now it may not be a sharp as the original Protos tool so you may either have to work longer at it, or cheat and chuck it in a drill. If you use a drill be careful not to over size them!

-Jay

Bradley Jones
01-19-2009, 10:36 AM
not sure what size the stock protos links are but heres a JR tool
http://www.readyheli.com/Ball_Link_Sizing_Tool_p/jrp960219.htm

copperkiid
01-19-2009, 12:25 PM
The JR tool is to big.