PDA

View Full Version : servo arm 90" how far linkage from center servo screw in mm


cobra25
01-25-2009, 10:02 PM
:arggg:

airjawed
01-25-2009, 10:05 PM
What gyro and servo?

pwoodyp
01-25-2009, 10:09 PM
Assuming the front three ---> but not the tail servo -->

Then ---> I could tell ya but I'd have to kill ya ---> If HS-65MG then ---> here's a clue.

http://w00d.servebeer.com/Servo_Horn.jpg

GreenCello
01-25-2009, 10:19 PM
13mm for cyclics, variable for tail servo

cobra25
01-25-2009, 10:23 PM
:shock:ok swashplate servos arms 90 linkage 12mm or 13 or it only matters until linkage arms are at 90 and they are hitec 65

cobra25
01-25-2009, 10:24 PM
i tryied 13mm and the linkage was not straight is 12mm ok then

R0t0R
01-25-2009, 10:27 PM
Basically it's whatever it takes to get the linkages vertical to the swash.

pwoodyp
01-25-2009, 10:32 PM
Yup pretty much what he said.... my first hole is 10mm (or is it 11mm, my eyes I tell ya) and the second hole 13mm... to equal spot on 90 I would have to drill a new hole.... :thumbup:

cobra25
01-25-2009, 10:37 PM
:thumbup:all of you great help thanks:noteworthy