Efliernz
01-31-2009, 10:15 PM
Has anyone seen anything like this?
Today I was flying this setup:
JR DSX9 (Known as the 9303 in the US) and AR7000.
Trex600E stock out-of-thebox setup 75A esc.
Hovering at approx 250 feet, 100 yards away and the motor goes silent for 3 seconds - then restarts. I have full control of the heli throughout. I have a DX7 user 5 yards from me.
Battery was ok (I have an onboard checker and low-volt alarm)
Two weeks ago:
Same TX with a stretched Trex600E.
different AR7000, CC HV85 esc. Different location. The same DX7 operator 5 yards from me.
Same 3 second break while staying in control.
The Trex600 has flown over two hours of airtime in the last two weeks (with the DX7 operator beside me). I haven't experienced any glitches except from the throttle issue on two different machines. The DX7 had a broken aerial last month and was replaced. I wonder if there is a chance of interference if the DX7 isn't healthy.
I'm really open to suggestions on this one...
Today I was flying this setup:
JR DSX9 (Known as the 9303 in the US) and AR7000.
Trex600E stock out-of-thebox setup 75A esc.
Hovering at approx 250 feet, 100 yards away and the motor goes silent for 3 seconds - then restarts. I have full control of the heli throughout. I have a DX7 user 5 yards from me.
Battery was ok (I have an onboard checker and low-volt alarm)
Two weeks ago:
Same TX with a stretched Trex600E.
different AR7000, CC HV85 esc. Different location. The same DX7 operator 5 yards from me.
Same 3 second break while staying in control.
The Trex600 has flown over two hours of airtime in the last two weeks (with the DX7 operator beside me). I haven't experienced any glitches except from the throttle issue on two different machines. The DX7 had a broken aerial last month and was replaced. I wonder if there is a chance of interference if the DX7 isn't healthy.
I'm really open to suggestions on this one...