HiBox on board

[marcelino]

Had my new HiBox logger installed for some flights. There was to see a 110 Amp@34.05 Volts "peak current/ minimum voltage" quick readout after flying.
Have to install the software on my PC to display whole flight now... but 3745.5 Watts as a peak power input seems to be nice :glasses:

other question is certainly how good is efficiency of this Motor at such high loads :?

Marcel

[marcelino]

should i maybe learn better collective management, like the pro`s do :?:

[pwkpete]

:shock:

Whoa

:shock:

[pwkpete]

Do you have a picture of the graph that scales better?

The gif is hard to read

[marcelino]

Will see what i can post. It seems that i had to zoom in at a certain area for better scale.
Thinner lines would be nice, but i seems there is no changeability for this. i need to ask where i bouth, for some instructions...

[BobbySmith]

Man that is hot numbers beleive me there is alot of people watching here HA iguess we can say we did it first :dontknow :smokin:

[marcelino]

:glasses:


Yesterday i did some flights with your 2200Headspeed +10/-10° Pitch setup, Bobby.

Motor is becoming really hot after 5:30 "Idle up" and i had to Put back about 2850mA.

Outside temp is 25-26 °C here now.

flying was little less agressive than Marcus on the video does.
The Rainbows are slower but short Tictoc`s are much easier to do.
GY 401 is working really well with this high tailspeed and CG fixed!

Think i need to install the logger again to see wat`s up.


If it`s possible for you to get 12,5 ° Pitch witch your Hardware, i would be interested to hear from you about flying with 1900 Headspeed. That`s about 52,5% throttle position for the 55-10-32 ESC in governor (Heli) mode.

Marcel

[BobbySmith]

Iam getting 4 minutes 30 seconds to 5 minutes on my setup i might have ot throw dataloggger on to but the performance is HOT!! there will a video up soon of some flying i did today