G$ Instructions

[TerryBelanger]

Just went to the site to get the G4 Frame instructions. They arem't there anymore. Anyone have them??

[ukgroucho]

Have you emailed Charley to let him know that the link is not there?

I don't have them but I have two assembled G4s here. Did you have a specific quation?

[TerryBelanger]

I have an SE. I need ot get the Tail drive shaft out of the bearing and bearing block so I can put it in the G4 frame. Any clue how to do it??

[Rotorworkz]

Terry,

For some reason during an update I must have broke a link, all fixed now thanks for pointting that out

Charley

[Foxden]

Terry,

The pinion on top is on a splined shaft, you should be able to pull the drive pinion off, then pop the upper bearing block off followed by the lower bearing block.

[ukgroucho]

Terryt,

To be honest I've always gone with new tail drive mechanisms when building these ... even when I wreck one and move stuff to a new frame I do not typically re-use bearings.

The tail drive brarings get a lot of hammer - they run quite high speeds in a not-so friendly environment (belt dust and what not) so I treat them as disposable - once in the bearing holder then they are done.