gaeric
06-15-2006, 09:03 PM
Hey everyone,
I have an eHawk that runs on two NiMH packs run in series w/ a 6v BEC going to channel 7 on Supreme 8 and ESC (with red wire removed) on throttle channel 3. I have an Optic 6 radio that I use and copied the setting from my T-REx over to.
Tonight I finally installed everything and got the servos all working in the correct directions, etc. Everything was working fine, so I unplugged and hooked up the Kotroniks Fun 500 motor and replugged in batteries. Tx was in bottom throttle position. CC-45HV beeped 6 times, but did not do the quick beeps at the end like my CC-35 does. Went to give it some throttle, and nothing. :badair: Servos all work fine and batteries are freshly charged, but no throttle.
Tried reversing ch. 3 in Tx, but no help, tried starting w/ throttle in highest position to enter ESC programming mode, but it would not...
For some reason it is not recognizing throttle input while everything else works fine.
Any ideas,
-ERic
I have an eHawk that runs on two NiMH packs run in series w/ a 6v BEC going to channel 7 on Supreme 8 and ESC (with red wire removed) on throttle channel 3. I have an Optic 6 radio that I use and copied the setting from my T-REx over to.
Tonight I finally installed everything and got the servos all working in the correct directions, etc. Everything was working fine, so I unplugged and hooked up the Kotroniks Fun 500 motor and replugged in batteries. Tx was in bottom throttle position. CC-45HV beeped 6 times, but did not do the quick beeps at the end like my CC-35 does. Went to give it some throttle, and nothing. :badair: Servos all work fine and batteries are freshly charged, but no throttle.
Tried reversing ch. 3 in Tx, but no help, tried starting w/ throttle in highest position to enter ESC programming mode, but it would not...
For some reason it is not recognizing throttle input while everything else works fine.
Any ideas,
-ERic