Uniball seperated form Clutch

[TerryBelanger]

I have a unibal that has seperated from the clutch stack. I was going to replace it with an extra one that I have but the extra one needs a new main bearing. Is this fixable or do I have to send them both off to be fixed?

[DavidH]

The uniball just pops onto the bottom of the clutch driver. The ball is sold separate 0546-3.
If the above is not what your referring to.
The clutch is screwed onto the driver. This is how the unit is held together. You can screw the clutch back onto the driver.
You can replace the bearing also by taking the unit apart.
David

[TerryBelanger]

Thanks david. SO I don't have to expoxy the uniball on or anything? I checked the manual but it just says, factory assembled

[DavidH]

The ball just pops on the bottom of the driver. You can use some thick CA or epoxy if you want. It will grip the ball to the driver long enough to get it installed.

David