Reconfiguring a 9303A to 9303H

[shawgl]

I am aware the software is the same however I would like to know if anyone has or knows how hard it will be to re locate the three position switch up to where it is on the heli version. Is it something pretty simple or I would have to send it to horizon?

Thanks,
Greg

[WayneBrown]

I did it after someone else posted the information in another thread.
Obviously you will removed the ratchet or order the heli version of the metal tab for the throttle, I filed off the ridges myself with the wife's emory board...
To relocate the switches, just unscrew the bezels, and remove them. There is very little slack in the wire harness, but there is just enough.
takes about 10 minutes to swap 'em.

[shawgl]

Sweet, I had done the click plate before on a 9CH but I never messed with relocating switches. I don't have the radio yet so I couldn't pull the back and look. I wanted to make sure before I bought it. Thanks for the help. Saved me some $$$$ by getting a hell of a deal on a 9303A.

[shawgl]

So tell me if I understand this switch position thing..... The top left back (gear) on the air goes to where the three position (flap) is on the air. The trainer button goes back to the top rear and the three position goes top front. Is that all? Is there any switch assignments that need to be redone to set the defaults correctly to their new positions? Any help would be greatly appreciated.

[WayneBrown]

Just swap the trainer (button) and the 3 position and you are done.

[shawgl]

Thanks, will do. I was going off of what I read on the Horizon site about what the differences. Makes sense to me. Thanks for the help.

Greg