8103 Swash mix expo??

[chrisg3]

Hey Freaks,
I have a question regarding programming exponential on my 8103. I have it set up with 120 degree ccpm swash mixing. I would like to add a little exponential for the cyclic control. On the swash mix menu I can set exponential to "active" or "inhibit". If I set it to "active" then where do I set the value of exponential that I want? Can I go back to the individual channel screens and set exponential on the individual channels (pitch, aieleron, collective)?
Thanks in advance,
Chris Garrison

[bigrcr]

No. There is no expo adjustments for the swash...BUT! This function will normally take out the very little bit of interaction that you cannot seem to get out between the collective control servos!

Later,

[chrisg3]

John,
Thanks for the reply.
Are you saying that exponential cannot be used on a ccpm heli with the 8103?
Regards,
Chris

[bigrcr]

No, I am not saying that. The Swash Expo can be used to remove some of the interaction in the CCPM servos. Expo can still be used normally in the dual rate and expo screen and in this mode you can use the percentages of positive and negative.

Later,