JR 388S circuit

[falconea45]

Does anyone know where I can get the circuits for the JR 388s. I am mainly interested in the connections to the TX module to see if I can put a DX6 module in there.

[big-al]

the 388 uses a tramsmitter module (as the majority of JR Radios use) and from what I've read, the transmitter board will not fit inside the standard module case. you would have to put another box on the rear of the transmitter to hold the bits of the spektrum system. I've looked at converting one over myself but just no time or money right now.

[falconea45]

Thanks for that Big-al, I have since found the connections quite by accident on a rcgroups thread. I don't want to have a box on the back as it would attract a lot of attention at FF's etc.
Thanks again

[Peter]

that would be because Spread Spectrum is not yet legal at most FF events in Australia as yet ...

[falconea45]

Hi Peter, Whats the situation with Spread Spectrum in Aus at the moment? Is it legal and what the go at Maaa wise

Clive

[Peter]

Its only approved for park flyers and small electric helis atm ... Seems silly to me , but thems the rules......

fromm MAAA site .. http://pdftohtml.spiritofanime.com/pdf2html.php?url=http://www.maaa.asn.au/mop/policy/MOP058%20-%20Policy%202.4%20GHz%20EQUIPMENT%20-%2021%20March%202006.pdf

:badair: :badair:

[falconea45]

Thanks Peter.

[flyoz]

The Spread spectrum doesnt have much (enough) range yet from what I understand. Even using the Multiplex scan for open freqs is frowned upon by the ill informed (aka old Crystal scratchers) :lol: who push for certification at each used freq :roll: