Strange throttle issue on Evo 50

[Gscott]

I've noticed a strange issue sometimes when I start my Evo 50. After the engine starts the throttle servo no longer responds to radio commands. If I kill the engine the servo begins to work normally again. If I cycle power to the receiver then everything is fine. I'm running a 50 Hyper with the CSM Revlock and a JR 811 servo. I'm still tuning the engine so I haven't even engaged the governor yet. Any ideas?

[Finless]

Hmmm hard to say.... Try removing the Revlock and see if it does the same thing..... I assume the other servos work? e.g. the RX is not in lockout or something?

Bob

[lennydude]

I think your on the right trail Bob..............That's the first thing I would check also....................

Lenny

[BarracudaHockey]

Yep bypass the governor if that doesnt work sounds alot like a bad servo but something is getting disturbed by vibration thats for sure.

[SteveL]

Is eveything else resopnding?

The machine could be licking out be careful.