Aux2 Channel is disabled - X9303?

[button head]

When I look under 'Device Sel,' Aux2 is set to 'Aux2 SW' & right below this is 'GYR.' I am not currently using the Aux2 channel. My Gear channel is set to Rudd D/R. When I look under the 'Trvl Adj' menu, I can see Aux3 & Aux4, but instead of seeing 'Aux2,' I see dashes with +100% -100% to the right of the dashes.

What can I do to have Aux displayed in Trvl Adj?

[Pinecone]

YOu need to turn off the Gyro under Aux2. Change it to Act.

[button head]

I tried turning Gyro to Act (under Aux2) but it would not change to anything else. However, I did figure how to access Aux2. I had to inhibit Gyro Sens which was set to Rudd D/R. I guess I'll have to use the Gear endpoints to adjust gain.

[Pinecone]

Sorry, I didn't think of that, but yes, if you turn gyro sense on, it takes over the Aux 2.

[button head]

Thanks, Pinecone. I actually found another thread titled "9303 gyro menu" in which you posted. It pretty much answered all my questions, making this thread somewhat unnecessary. I should have searched a bit more thoroughly. I appreciate it though. Let me attempt to make this thread useful, however.

The last time I flew the 600N I had Gyro Sens set to Rudd D/R, but when I made adjustments to Position 0 (HH) it appeared to do nothing. I noticed the following:

1. Under Gyro Sens, if I apply full right stick & then release, the tail rotor would hold regardless if position 0 (HH) was at 0 or 100.

2. With Gyro Sens inhibited & using EPA, if I apply full right stick & release, the tail rotor would hold at +100, but the tail rotor would center itself at +0.

This tells me that my setup only allows me to use EPA to adjust gain, rather than having the option of using either EPA or Gyro Sens. I have the green gain wire from my Arizona going to the Gear channel of my R921 receiver, is this wrong?

[spike5150]

It is not wrong, but if you plug the gain lead into Aux2 then you can use the Gyro Sense menu to have different gain settings for each flight mode position. on the 9303, the gear channel is "reserved" for the GOVernor. I guess you are not using a governor on your 600N?

[button head]

My govorner just arrived today (ATG v3). Will be installing soon. The govornor's instructions say any available aux channel can be used, I'll probably put it to the gear channel though.

[spike5150]

Yes but the 9303 will only let you use the GOV menu with Gear Channel. However you can use endpoints, switches and programmable mixes to set it up however you want.