7CHP stick assignments

[ronaldf]

Can stick assignments be switched on a 7CHP? if so where can I find the instructions? I can't find it in the manual.

[supertrex2]

I dnt think you can do that... u can switch the IDLE and TH hold. though.

[spork]

Can stick assignments be switched on a 7CHP? if so where can I find the instructions? I can't find it in the manual.

I don't know if it can be done through the UI. But I bet it'd be real easy to do with a soldering iron. As far as I'm concerned, nothing is really ready for use until it's been modified :mrgreen:

[the collective]

Can stick assignments be switched on a 7CHP?


If you're referring to switching from the standard Mode2 to Mode1, then yes. Just hold the Mode and END buttons down while turning on the power and you'll get a menu that allows you to specify the stick mode. Make your choice, then power off and back on again and you'll be in the new mode until you decide to change it again.

[ronaldf]

Thanks for the answers. I found that I really didn't need to switch stick assignments. I just had to get all the normal setting correct to start with. I found the instructions on another forum. Once I got the elevator servo set properly, then I used finless' video to get the remaining settings correct.

[jahunter]

I am an engineer, with lots of RC experience, and I am having a lot of trouble programming my 7CHP.

[spork]

I am an engineer, with lots of RC experience, and I am having a lot of trouble programming my 7CHP.

There's a chance we'll need more detail if you're looking for help. If you're just offering an observation I guess we're good to go. :D

[BarracudaHockey]

It doesn't always pay to be too smart :D

[Pokerstar]

Wow, BarracudaHockey,

I must be set for life then! :dontknow