View Full Version : 6v on the CSM Sl720 and 9256?
ethinger
06-20-2006, 07:15 AM
does anyone know if i could use this set up?
SteveL
06-20-2006, 02:15 PM
No the 9256 is only rated @ 4.8v I found the info on this page
http://www.futaba-rc.com/servos/digitalservos.html
gyro can take it but the servo cant.
ethinger
06-21-2006, 01:00 PM
A fully charged sub C 4 cells is rated at about 5.4 v... it is safe to run this on that Servo?
mingming
06-23-2006, 12:51 AM
A fully charged sub C 4 cells is rated at about 5.4 v... it is safe to run this on that Servo?
i am using BEC + 11.1V 2200mah li-po batteries and it works perfect and long lasting than traditional NiCd pack.
The BEC costs US$20. Since i am using S3001 servo which supports 4.8/6V, i can switch the BEC to 6V to power up the servo to have better performance.
Specification:
1.Output: 5V/3A and 6V/3A switchable
2.Ripple: <50mVp-p(@2A/12V)
3.Input : 5.5V-23V (2-5S lithium battery pack,5-15 cells NiMh/NiCd pack)
4.Size : 41.6mm*16.6mm*7.0mm (length*width*height)
5.Weight: 6g(input and output cables not included); 8g(cables included)