Electrical Build question 600ESP

[whoanelly]

hey guys noob here to 600s,,just built the 600ESP and now im ready for my electronics.my question is that i noticed on this set up my BEC does not attach in anyway to my ESC,so do i still need to diconnect the red wire to my ESC when running this BEC:dontknow.

all the components are stock that came with purchase..

Thanks Guys .

[snjbird]

I did not?

[whoanelly]

Appretiate that.but not sure how to take it,,lol..it hasnt affected anything like tempature? or anything else? for you. just trying to make sure i do this right .

Thanks.

[RCSavager]

There is no BEC in the ESC so no reason to disconnect wires. :thumbup:

[james1281]

Page 26 of the manual says: "When using a speed controller with BEC output, you must remove the red wire of BEC output on the speed controller".

If you are using the stock 100amp ESC, DO NOT CUT OR REMOVE ANY WIRES!! There is no BEC in the Align ESC. Some aftermarket ESC's come with internal BEC's and in that case you would have to elimiate that circuit since you are using a seperate system for your receiver power.

Good Luck & Have Fun!!

James

[whoanelly]

Thanks guys ,,Kinda new at all this electronics so i do appretiate it.