Synergy N9 - What's your setup ??

[EKIM]

Hey guys. I'm almost done collecting all of my parts. I just need a pipe. Can anyone post a link for the right hatori pipe for the OS SZH pumped on the synergy? I spoke to synergy rc and they said to go with the sb18 for os engines, but I noticed that it says that the sb18 is for the c-spec only.

[Simon Lockington]

Another tip, if you are going to be using a YS engine and the Hatori 937 exhaust. Make sure you use some spacers to move the pipe out from the side of the engine a bit else you'll burn through your fuel tank when it is pressurized...

Si

[nigel]

Hi All,


The Hatoris sold from Asia number 937 and 938 have a shorter header extension compared to the American version know as the SB18FH. You will need this version to clear the tank adequately. Or if you have the 937/938 you can use a funtech spacer between the motor and the flange.


Current setup.

YS91ST
Hatori 937 ( with funtech spacer )
Futaba 9255's all round
Futaba 611
Futaba GV-1 set to 1850 rpm idle 1
Fromeco Arizona regulator set to 6V on cyclic
Fromeco Peerless 4800mAh lithium ions
V-710mm mains
V-105mm tails
20% Coolpower (GRUNTER)

Built as per the book with no guess work, rod lenghts where all perfect as per the cad drawings


Cheers

Nigel Brown

[Scooterpilot]

UPS is scheduled to deliver the kit on 15 Aug 06


OS 91 Hyper Regulator/pumped
SAB's 710's
Servo 94758's
Gyro 611
Dualite 6.0V with gyro regulated to 4.8V
Hatori SB 18
Magnum 30%
Throttle Servo 9254 with a TJ Rev Max

[Helidbe]

Hi,

Here is my setup

http://www.daviddutrieux.com/index.php?file=Sections&op=article&artid=18

I put somes pictures also to show somes details.

Cheer,

David

[vinny]

Mine is on order also.
The parts I have are:
9351's for cyclic
9252 throttle
GV1
611
710 sabs
110 V's
Ys 91 viper
Power master 30%
Parts I need
Kit :), pipe and power system
As soon as its ready the new Durilite power system for Heli's.
Until the new system is ready it wil just be 4.8 (2400) nicads should be more then enough for the 10 minute flight.

[cdrking]

vinny

What's the new Duralite system?


Jeff

[vinny]

From what I here its going to be just a bit bigger than a switch, have 2 separate battery inputs deseigned for 2s2p packs, given you the option of a single or dual redundancy. You could lose a pack and a half and still be safe. A reg for 6 volts and a reg for the gyro. Its deseigned for use in a vibrating environment. And the big one if it fails it’s supposed to be designed fail to a lower voltage instead of wide open.

[wascheck]

My setup is :
9451's for cyclic
9252 throttle
GV1
Gyro 611
710 V Blades
105 V Blades
OS SZH 91 pumped viperhead
Coolpower 30%
Duralite 4000 mha 6,0 volts regulator and stepdown.
Radio Futaba 9CHPS Sint.