Trouble saving idle up curves on 7C FAAST

[zizzy69]

Hi. I'm working on setting up my 7c for a T-rex clone. The issue I'm having is that I want to set pitch and throttle curves for my idle ups. Here is what I have done so far. I went into the advanced menu for curves and turned INH to "off" for N(1) and N(2). When I switch to idle up 1 on the tx top switch, the N(1) setting changes from off to on. So now I think I'm good to program my curves. I put in my settings and exit. The problem is that now it has saved my new curves under N(N). In other words, its overwrites my new curves under the normal settings. I can verify this by going out of the advanced menu and into the basic menu, which only allows changes to the N(N), where my new curves will also display. These changes will stay no matter what position my idle up switch is. I've checked the 7C manual and the futaba FAQs but there is nothing on the topic. If anybody can help I would GREATLY appreciate it.

Thanks in advance.\

[The_Trooper]

Scroll up to the N, then use jog dial to change to 1 or 2 then put in the curve.
It must be set on the throttle curve setting,not the N throttle curve in the menu.:thumbup:

[zizzy69]

Scroll up to the N, then use jog dial to change to 1 or 2 then put in the curve.
It must be set on the throttle curve setting,not the N throttle curve in the menu.:thumbup:


Many thanks...I can't believe I missed that.:arggg: