FrittsLogic
07-15-2006, 06:24 PM
Since the 9254 fits so perfectly in the servo mount opening in the Lepton frame, it seemed to me that it was meant to be there. I didn't want to drill extra holes in a thin area of the frame to use bolts, and I don't have the ability to make special CF pieces to hold it in. I did notice the slots above and below the hole could somehow be used to hold the servo in, so I came up with this extremely expensive and technically challenging solution. It employs one of my favorites, tie-wrap technology. The use of two tie-wraps provides redundancy, not that I expect them to come loose anyway, but you never know. No alterations to the Lepton or the 9254 were required for this install. I did leave the rubber grommets on all 4 holes to provide vibration dampening.
I have the photos of this in a post on runryder:
http://www.runryder.com/helicopter/t271814p1/?p=2105831&top=1153001856#RR
I have the photos of this in a post on runryder:
http://www.runryder.com/helicopter/t271814p1/?p=2105831&top=1153001856#RR