View Full Version : Stratus engine plate
Rada70
07-22-2006, 06:53 PM
Hi all,
I have a stratus with YS engine. I want to put in OS SZH non-pumped engine instead. I have the new plates for the 8.18 gear ratio and the 90 tooth main gear.
what's left is the engine plate. Is it one or two piece plate? I am not sure.
DavidH
07-22-2006, 07:44 PM
You will need part number 126-32
http://www.miniatureaircraftusa.com/Store/proddetail.asp?prod=126%2D32
David
Rada70
07-23-2006, 11:35 AM
OK David thanks. So there is no need for the second smaller plate used on the OS c-spec. Am I right?
Dr.Ben
07-23-2006, 12:20 PM
SZ-H's use a single bottom plate and the thrust washer under the fan. The bottom plate is characterized by a milled down surface in the center of the plate.
Ben Minor
Rada70
07-23-2006, 09:18 PM
OK. thanks guys.
bueno
08-03-2006, 06:51 PM
SZ-H's use a single bottom plate and the thrust washer under the fan. The bottom plate is characterized by a milled down surface in the center of the plate.
Ben Minor
Excuse me I'm new at this and not that versed on posting....I just have a question. For the 91SZ-H engine is the pump that is attached to the bottom of the engine backplate "sandwiched" between the 126-32 plate and the engine backplate or do you move it to the opposite side of the milled 126-32 plate. Thanks,
DavidH
08-03-2006, 07:04 PM
Take the pump off the bottom of the engine. Then installed the plate with the milled side towards the back plate of the engine. Then the pump will be installed on the other side of the carbon plate.
The plate is mounted between the pump and the back plate of the engine.
David
bueno
08-04-2006, 04:56 PM
Thanks, very much for your quick response.