MrMel
07-25-2006, 06:42 AM
I run a gy611/9256 combo on my Logo 10 3D, however, when doing a right piro and stopping, the tail creeps back a bit, Its not a firm stop.
It doesnt matter if its a fast or slow piro.
The mechanically setup of the tail is correct according to the manual (arms at 90degrees)
Ived tried different settings on the gyro without luck (in F3C mode its more like a bounce back, in 3D mode its creeping back.)
It only creeps/bounce back a certain distance, then it stops (about an inch or two)
The left piro stops superfast and firm (like hitting a brick wall)
Well, this issue has got me stumped, never seen it before.
Anyone have some ideas?
Ive tried raising the gain to 42 (from 37) it helped a bit, but not much
I also tried tracking, didnt help much
While searching the web ive seen numerous with the same problem on different heli's so it seems its gyro related somehow.
It doesnt matter if its a fast or slow piro.
The mechanically setup of the tail is correct according to the manual (arms at 90degrees)
Ived tried different settings on the gyro without luck (in F3C mode its more like a bounce back, in 3D mode its creeping back.)
It only creeps/bounce back a certain distance, then it stops (about an inch or two)
The left piro stops superfast and firm (like hitting a brick wall)
Well, this issue has got me stumped, never seen it before.
Anyone have some ideas?
Ive tried raising the gain to 42 (from 37) it helped a bit, but not much
I also tried tracking, didnt help much
While searching the web ive seen numerous with the same problem on different heli's so it seems its gyro related somehow.