Servos for Flybarless Rave

[Alex500]

Hi
I just ordered an Rave 450 4s Flybarless Kit. Here is my planned Setup:

Radix 350mm Main Blades
Radix 59mm Tail Blades
Scorpion 2221-10
YGE 40A Controller (3A/5A BEC, only 35g including wires, excellent Governour-Mode)
Mini VStabi (Flybarless System with included receiver. You just need to plug-in a Spectrum Satellite)
S9257 Tail Servo
Zippy Flightpower 2200mAH 20C 4s Lipos (228g including wires)

Now I'm not sure about the servos. I need powerfull and fast servos for the flybarless system. Can you recommend the Savox SH-0257MG or the Hitec HS-5065MG? Both are not so expensive in Germany.

Best regards from Germany, Alex

[deesee]

HS-5065 should work great! Is the mini v-bar available in Germany?

[Alex500]

The Mini VBar is available now. Should be perfect for the Rave.

Best regards, Alex

[Heliguy3D]

I am interested in the mini-V for the Rave also. Do post some test results. Thanks.;) The Rave flybarless head looks soooo nice.:)

[OlegM]

The Mini VBar is available now. Should be perfect for the Rave.


But price for Mini VBar is cruel...

[Alex500]

But price for Mini VBar is cruel...

Well, you always get what you pay for. I have the regular VBar in my T-Rex 500 and it works just perfect. Easy to setup und excellent performance. There is no better system on the market except AC3X (as good as VBar or maybe a little bit better, but a shade higher in price).

Best regards, Alex

[dhoff002]

I have the mini vbar on my rave and it is flying great. Very easy to setup and install, and I mounted the mini vbar underneath the main shaft, where my gyro was before. Only thing was that I had to order an 90 degree mini usb cable in order to plug the vbar cable.

Dan

[Serbi]

I have the mini vbar on my rave and it is flying great. Very easy to setup and install, and I mounted the mini vbar underneath the main shaft, where my gyro was before. Only thing was that I had to order an 90 degree mini usb cable in order to plug the vbar cable.

Dan
I'm also going to convert one of my Raves (I have 2 :) to FBL with a Mikado Mini. Could you PM me the settings? Thanks a lot!

[Sky Dancer]

I've built the new Rave FBL head and I'm just waiting on the new "TOTAL-G" to be available. That's definately the Flight Control System I want to get.

[mahbouni]

Well, you always get what you pay for. I have the regular VBar in my T-Rex 500 and it works just perfect. Easy to setup und excellent performance. There is no better system on the market except AC3X (as good as VBar or maybe a little bit better, but a shade higher in price).

Best regards, AlexI tried to buy an AC-3X. I sent an email to them but never even got a response. Aparently they don't sell outside Germany. After that I bought a Gyrobot 900 and I'm happy with it. It's currently in my Sniper II. I may get a Mini V-Bar for my Rave but I'll wait to see the Curtis youngblood offering before I decide.

[BOOGIE]

I had truble with some 5065s in my Flybarless Rave They went out on me, Maybe I got a bad set. I sent them back and they sent me 3 new servos.