mini-g servo creep, need help

[JASON671]

at the last part of my rebuild doing tail setup i noticed that after initial setup and rebind, my tail servo is creeping after i give right rudder. what could cause this?

[ch3no2Phil]

I have seen the Mini-G do this. From what I hear it is normal and will not happen in flight

Phil

[Sky Dancer]

at the last part of my rebuild doing tail setup i noticed that after initial setup and rebind, my tail servo is creeping after i give right rudder.


The Mini-G should not have any TR drifting. I'm a little unsure what you mean by
"my tail servo is creeping after I give right rudder"? Does it drift after you connect your lipo or only after you give right rudder?

Did the Mini-G suffer any visible damage in your crash?

It sounds like you might have some trim or sub-trim in your TX setup or the TX rudder stick is not centering properly. I'd make sure all trims and sub-trims are at 0 and then rebind again and test for creeping.

Don C :)

[JASON671]

i checked over everything, and all looks good, no trims in the tx. i took it out for a quick flight and the tail held perfect. but on the bench my tail servo always creeps all the way to the right. but in flight its perfect. :thinking

[PhnX]

I have same servo creep on my SolidG & Bls251. It holds like it should but I just have the creep when idle and on bench.

I just pretend like I've never seen it :) .

[Jamesppp]

I just set up a Mini G and it does the same thing.

[JASON671]

the mini-g is weird on the bench but in the air it holds like a champ!