Paralell TP1320's

[chevpro]

Can two TP1320's be used in paralell on a Trex 450?
The way I see it I will still get 11.1v but I will get 2640mah.
Is this correct and do I have to worry about over amping??

Todd

[Ultraviolet]

Overamping on lipos ? huh ? Overamping is a function of the
load.....NOT the supply.

As far as running two 1320's...............spec follows ;

TP1320-3S 1320 mAh, 3 cells (11.1V), 16G wire, 4-pin balancer connector
Rating: 13C (17A) continuous, 20C (27A) burst
Dimension: 34mm x 65mm x 19mm
Weight: 85gm
$54.95

The weight would work out at 170 grams. Two lipos stacked on top of each
other would maybe fit on an SE, but would not fit a CDE or HDE. A custom
mounting scheme would need to be devised.

The price of $110 for two lipos would also not be cost effective. Basically you
have nothing to gain and everything to lose. :wink:

[enigma]

unless you have two laying around, then they are not much heavier than a Apex 2100mah 3s1p (165 gram) If that's the case, go for it, just don't buy new ones for the project. You can link them with wires/plugs to help with the mounting issue.