View Full Version : Multi gov and atv ??????
maxman55
09-25-2009, 05:25 PM
Today i finally finish up my 600, in the throtle servo set up i tried to set without using atv but was imposible to ge the high point without atv. end up with atv at 110 / 100 will this be a problem with the multi gov? i'm in the breakin part without the multi gov, soon i will finish breaking and connect the multi gov.
Straithate
09-25-2009, 05:47 PM
No, it should be fine, mine is 100/95 and it works great.
If you can attempt to get it a little closer to +/- 5 that would probably be best.
pril250
09-25-2009, 05:47 PM
If you are sure the throttle servo is setup ok then it should not pose a problem.
Just to be on the safe side watch Finless video on setting up the throttle.
http://video.helifreak.com/?subpath=finless/trex600_nitro&filename=step13.wmv
chadjay
09-25-2009, 05:52 PM
Just make sure to program the throttle idle and high in MGP AFTER you reset your ATVs. The MGP has to know the full range of throttle to operate properly.
maxman55
09-25-2009, 06:29 PM
No, it should be fine, mine is 100/95 and it works great.
If you can attempt to get it a little closer to +/- 5 that would probably be best.
Ok i will try to reset the carb and try to get a little closer.