How to mount HS-56 servos on Askman Trex AP?

[catfight]

Just received my Askman APLG T-rex Pro mount but cannot figure out how to mount the HS-56 servo- anyone have photos or can describe for me?

Thanks

[askman]

if you go to my website and look under apcam, there is a good pictures of it. I've been meaning to update the instruction, but been very busy. (I will do a photo instructions very soon)

[catfight]

askman,

Thanks for the reply! I looked at the site at the AP photos but still do not see how you installed the hs56 for tilt. How is it attached (glue)? :0)

Got my first aerial movie (640x 480 at 30 fps) thanks to your mount! I just velcroed the tilt together for a straight out shot - pretty decent. Mount flies well- I did a couple of stationary flips (without camera!) just to get familiar with the mount.

Thanks

[askman]

use the two 3/8" 2-56 screw that is included and the side mounting tab on the HS56 servo. there is two predrilled hole that just fit the screw (self tappig) use the ball link that is included to connect it up.

[catfight]

askman,

Oops!

Forgot- I had clipped off the tabs to use in my frame! Rats- have to buy some more servos (that explains my mounting problem).

[askman]

you can always use two sided tape or glue it on as well. :)