CitationX
08-19-2006, 09:25 AM
I recently upgraded my Extreme from a YS80 to an OS.91-SZ. In the process it freed up the following items:
YS80
Hatori SB-16 SOLD
Eric Stolz aftermarket clamp SOLD
Engine Mount (both right & left hand sides)
8.45:1 Gear kit (main & pinion) along with the carbon side plates
Check valve
All of these items have been on my Extreme for 2-1/2 years. This past winter I took the opportunity to overhaul the engine by replacing the rear bearing, piston, ring, and a variety of gaskets.
This entire set up is plug and play for upgrading a Fury Expert to an Extreme. There is no need for shimming the engine back because the mounts are specific to the 8.45 gear ratio. Everything is in excellent condition.
Pictures in gallery.
YS80
Hatori SB-16 SOLD
Eric Stolz aftermarket clamp SOLD
Engine Mount (both right & left hand sides)
8.45:1 Gear kit (main & pinion) along with the carbon side plates
Check valve
All of these items have been on my Extreme for 2-1/2 years. This past winter I took the opportunity to overhaul the engine by replacing the rear bearing, piston, ring, and a variety of gaskets.
This entire set up is plug and play for upgrading a Fury Expert to an Extreme. There is no need for shimming the engine back because the mounts are specific to the 8.45 gear ratio. Everything is in excellent condition.
Pictures in gallery.