anyone spektrumized thier blade and use the JR 6102?

[kama1]

i did the spectrum 6102 mod a lil while back.
just resently threw a spektrum RX in my blade.
i having some problems with the pitch and throttle curves.
if anyone has this setup also could you post your curves please?
thanks

[steve28]

yah i did it and I have it running good .

E-flight 370 park 3600 KV BL motor , 10 A ESC
stock tail motor , GWS 5 A ESC
Futaba G190 gyro

whats your problem
what motor are you running ? ?

[Funky]

I have a spectrum 6102 running my Blade pro. I am running stock 370 motor and stock tail rotor. It took a lot of time with servo arms and sub trim to finally get it right. My thottle curve now is 0, 50, 80, 90, 100 in normal and 100, 100, 100, 100, 100 in Idle up. I had to make some adjusments for throttle overall travel and made a few modifications to the swash menu to get the right amount of throw from my servos. The book says to run -12 to +12 for idle up but the motor really doesnt have the power. I lowered mine to about -10 to +10 and got a better climbout rate... but its still really slow. Once I got -10 and +10 for my pitch throws with 0 pitch at center stick, I set up my pitch curves as 0, 35, 50, 75, 100 for normal mode and 0, 25, 50, 75, 100 for idle up. I will be going brushless very soon. The only mods I really have on it now are align blades cut down and an align feathering shaft grinded down to the size of the Blade feathering shaft. I tried the E-Flite carbon blades yesterday and they didnt really make a difference in my climbouts compared to the align blades i have been cutting down. I would have to try them back to back though to see if that is part of my climbing rate problem.

[kama1]

ahh...thats where im getting messed up is with the servo throws.
thanks for the info...ill start monkeying with the sub trims
thanks again :)

[steve28]

my setup is still on the old CP head design not the new upgrade head , but it works right now Im no 3D flyer , i just fly circuits right now. My climb out rates are pretty good , but I dont like to punch it as Im using revo mix on the tail ( no HH ) the revo mix isnt perfect and so if I punch it the tail drifts , if I climb slower it doesnt do that so much .
Im also not using either the 4 in one or the 3 in one , Im using all separate electronics with BL motor.