XP 8103 ?

[bullit67]

OK every one I am building a Trex I am at the programing stage so I sat down today to set up my servos I an using a JR XP 8103 with a hitech electron 6 RX I pluged in the 3 servos and a Rec. pack for power when I turn on the TX all I get is glitching. :arggg: I tryed recharging the Rx pack just to make sure it had enough power the servos dont do any thing untill I try some input the TX is used I am starting to wonder if it is junk it dosent show any damage from being droped or any thing. Any one have any ideas?

[capebob]

Is your Electron 6 positive shift (JR) or negative shift (Futaba)? You must have a positive shift receiver to work with your JR transmitter. Is the transmitter new, of did you buy it used? Also, you must have the right type of crystal on the same frequency as your transmitter. The electron 6 uses a dual conversion crystal and JR receivers use single conversion crystals. So, if you are trying to use the Electron 6 with a JR crystal it won't work.

Bob