View Full Version : Question About Center Hub Assembly
wolfdown
11-12-2009, 08:21 PM
From the 1st build step, can anyone tell me if the factory installed bearings should be installed flush with the outward facing side of the center hub? :thinking I took out the bearing sleeve because the clearance for the SeeSaw was too tight, and now can't remember how the ball bearings looked originally. Thanks.
Foxden
11-12-2009, 09:25 PM
Yes,
The bearing and the brass sleeve go in from the outside of the hub
wolfdown
11-12-2009, 10:26 PM
My bearings are sticking out about 0.5mm. If I apply pressure will they push in farther? Any tips on how to do this?
Foxden
11-13-2009, 08:43 AM
My bearings are sticking out about 0.5mm. If I apply pressure will they push in farther? Any tips on how to do this?
Look at the top of page 2 in the manual, the bearing pushes into a pocket in the center hub, you should be able to look from the inside of the hub and make sure the bearing is fully seated in the hub, I simply use a hex driver and push the bearing in until it seats