Jr 500T Over Driving Rudder Servo ??

[wvoutlaws]

New Gyro in TREX and Spectrum Radio
Plugged Rudder servin to reciever and set arm length to get 100 atv with out binding app 10 mm out on arm
connect gyro and servo travel much farther
tried to adj with gyro endpoint dial and still too much
tail very twitchy
ended up with 30 % rudder atv to calm down and still binds linkage
Is this normal,bad gyro?
plugged in a eflight gyro and its ok

[bighands3d]

to set a 500T u must set the atv's 150 both sides and us the duel rates to ajust speed of piro us expo to soften the stop 20-30% usually good place to start.

you have to use the manual pot to adjust end point and reduce your servo arm length. you may have to be in the nearist hole to the scew to keep from binding the servo.