View Full Version : Outrage Fusion 50

Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 [28]

Hoa Vu
04-05-2011, 09:00 PM
Will a Velocity canopy fit the Fusion?
No, it doesn't.

04-06-2011, 12:14 AM
The 6mm supports are in stock at HD if anyone still needs one.

wow sold out already

04-06-2011, 03:59 PM

Helidirect just send me the fusion 50! I think it will arrive on wednesday (I live in spain)

My setup:

DS610 x3
DS650 tail
I donīt know what FBL Im going to use...
Nanotech 3300mah 25-30C Turnigy 3000 30C

04-10-2011, 12:05 PM
Still having issues with mine.

Well finally put it all back together last night and left the tail till last. When I put the tail back on the boom no matter how loose or tight the tail gearbox was it still spins on the boom. I was purposely turning the tail gearbox while doing it up and at no point was it tight enough for me not to be able to spin it quite easily by hand. I tried this on my other helis including the Logo's which are not pinned and they dont budge. So I even tried putting a layer of that tape stuff on the boom first, no joy it still spins. I cant believe this heli and I will not fly it. It was a new boom but not a new tail gearbox bit!!!
I have drill's etc to pin the boom which I attempted but you need such a short screw its incredible, then its got to hold in place on the thin boom.

Well Im sorry but until a resolution/mod or whatever comes from Outrage I will not fly this heli. I should not NEED to do a mod to a bnib ****ing model!!!!

To say Im ****ing furious is an understatement!!

04-12-2011, 10:43 PM
I hope you get it sorted out fast.

Outrage is pretty fast with fixes

04-13-2011, 12:59 AM
In the States maybe.

I have seen Outrage on here sort many issues and RC Hub, the UK distibutor did originally give me assistance eventually but the problem still remains and now I'm just getting ignored.

I think its incredible but im now wondering from how I have seen Outrage sort and help out people here if they even know about my issue??

I have emailed them as well as RC Hub and will give it till the end of today to get a response and will go from there.

04-14-2011, 07:51 PM
Wonder if you guys can help.. I changed my bearing support to the 6mm one since I got a new motor with 6mm shaft now the bearing itself rise out of the housing all the way to the pinion I tried to put shoo gu but it only work for 3 flights.. Any ideas what I should do?

04-14-2011, 09:07 PM
Does the bearing fit very loose and sloppy or just a little bit? You could use red or green loctite

04-14-2011, 10:23 PM
Does the bearing fit very loose and sloppy or just a little bit? You could use red or green loctite

its just a little bit, cant push it out by hand but it spin up @ hight speed

04-15-2011, 01:49 AM
I would use green loctite or lower the pinion to hold it down.

04-15-2011, 03:29 AM
Loctite 603 or 648 should help.

04-15-2011, 12:52 PM
Thank guys..