dx6 problem

[pugger86]

Has anyone else had a problem with the Spektrum dx6 binding to the receiver? It was working and after powering down the transmitter and unplugging the receiver they dont see each other and will not bind . The light on the tranmitter flashes and then goes solid but it never stops blinking on receiver. If I remove the binding plug I get no lights on the reciever. The servos will center and I can hear the gyro working so i'm guessing I maybe doing something wrong.

This is happening with or without any of the servos plugged in. And the green light on the transmitter never goes off.

And after spending all that time getting those sevos into the frame(mx400 pro) I dont want to take them back out to return them.

[pugger86]

I returned it for another one and it works fine. Not sure if it was the tx or the rx .

[bmlasater]

fwiw..

We've seen a lot of therse units in the last year, only a couple have had issues,,,Just return it to Horizon, they'll make it right...

John.

[diverjack]

If you look in the DX6 manual, it's already bound from the factory! No need to bind on initial setup.



Jack in Calgary
T-Rex 450 SA
DX6 1500mah battery
Hitec servos all around
etc etc etc ;)