View Full Version : Elevator End Point Settings
I have an intrepid using a S9252 on the elev and the end points for it are 58 & 62 this seems a little bit low Should I be using a smaller wheel & increasing travel? Balls are 20MM apart on the wheel now. Thanks
No one can give me their elevator end point settings?? WOW.
PaulH
10-06-2006, 12:18 PM
Your end point settings will depend on the amount of cyclic pitch you want in both axes. I would think that you could move both of the balls closer to the center of the wheel, but I honestly don't know if this would throw off the parallelogram formed by the pull-pull setup.
Chris or Malorie could better answer that.
cbergen
10-06-2006, 12:22 PM
I think your post got lost in the shuffle....
58 and 62 is definitely on the low side. Typically I set up with 85% on both sides.
With these settings(58 and 62), is your swashplate bottoming out on the main shaft?
It won't hurt to go smaller on the wheel diameter and raise the ATV's
As always Chris to the rescue. Thanks Chris