joker2 cam setup

[askman]

it is going to be very similiar to joker 1 setup in layout.

I got the new side frame all coded up. I am making it .5" taller than stock. (I hope that is satisfactory with most of people) also, I am taking about 2" off the nose and move to the back just like I did on the joker 1 for CG benefit. in someways, this is easier one to design compared to joker cx, and lot of the parts are interchangeable. anyway, early next week, I will have some proto part to send to one of my tester for test fit. once I get an ok, I should have first ones available by end of next week.

first of trex600 nose cam (with bottom battery plate) should be mounted this weeknd as well. :)

[Tonystott]

Keep up the great work Andrey!

[rroback]

good work. I can't wait to see it, and maybe buy one :) Will it have the vib dampener's like the raptorcam?

[askman]

yes. it will have vibration dampening system. I use slightly different damper elastomer, but effect is very similiar and I also use 3 point. plus, I am working on roll stabilization. I think I have a simple swing damping. need to test it though.