View Full Version : Lithium Poly for 9303
Lzfalcon
10-08-2006, 09:04 PM
The battery pack in my 9303 is 9.6 volt 600 mAh. i was reading that Duralite has a battery listed that indicates that it's a 11.1 volt 1300 6cell. Does this mean that the 9303 can take 11.1 volts, or does the Duralite have a voltage regulator that reduces the pack to 9.6? Or was it a typo.
Thanks
SweetF
01-10-2007, 01:10 PM
I have been using a Li-poly 2500 in both my 9303's for over a year ,with no problems,,after a full charge it shows 12.3 volts ,and I use my tranmitters pretty hard almost every day,,the module on the back get's warm but JR said it was ok ,I got my Lipos from Common Sence RC
WayneBrown
01-10-2007, 08:58 PM
the Duralite packs are a drop in replacement, and the voltage is 11.1V.
the charger has charge safe circuitry, so it's plug and forget.
I have two in my radios, and all my nitro choppers and would not go back to NiCd's.
SweetF
01-10-2007, 09:06 PM
Yep would not go back !!!!!!!!!!
Do you guys leave the lipos in the Tx while charging or pull them up to recharge ?
WayneBrown
01-11-2007, 01:54 AM
I leave mine installed, Duralite is the only brand I would truct to do this with however...
SweetF
01-11-2007, 10:31 AM
I pull mine ,,to me ""they are poly"" and anything could happen
Fall2Fast
05-28-2007, 11:12 AM
I have one in a 9303, it only lasted about a year and a half. upon recharging the light on the charger stayed very bright for a long time, so I felt the radio, it was VERY hot at the batt, but no damage, anyhow it will not charge anymore and shows no voltage. Out of warr too... But when it worked, it worked!
Magic Man
10-03-2007, 09:58 PM
,,the module on the back get's warm but JR said it was ok ,I got my Lipos from Common Sence RC
JR says it's OK???
Better check with them again and stop spreading misinformation!
I use NO BS batteries. My 1800mah pack last 8 hours on the 9303 and takes under 2 hours to recharge.