where and how to put the blade-spacers

[xircom]

Using the MS blades, I need to use 3 spacers for the right distance of the blade holders, two delivered by MS and one from the stock blades (see picture). The one from the stock blades is thinner (maybe 30% of MS spacers), wider in diameter, and also has one flat and one rough textured side.

Now what would be the order (and side) of how to mount the spacers ? I used to

holder (top)
MS spacer
blade
MS spacer
Stock Spacer (rough side down)
holder (down)

what do you think ?

[3secondsToImpact]

Hi Xircom

My opinion(which means nothing according to my wife) is that the blades will be slightly off center no matter what configuration with the odd out stock spacer.

the only way to get centered blades would be to measure thickness of stock spacer and get, make, borrow or steal 2 spacers when together is same thickness as the 1 stock spacer and then I would use these modified spacers against the blade grips with MS spacers against blades. This is the method I am using and another + was changing the mains my vibrations on tail went BYE BYE! (you can cut a diamond on my leptons tail now).