Throttle Jockey Rev max 12z help

[Mike J]

Iv'e got my Revmax all setup on my new fury extreme :D Thing is I would like to set the switch to "E" so I could have idle up1 say at 1750, and idle up2 at say 1850. Only problem is the switch is in the on position all the way back (normal mode) off in the middle (idle up1) and on in the nearest position (idle up2) Iv'e gone into the function menu and selected switch E but it doesn't give you the option of orientation of the switch. Anyone with a 12z know how to change that? Or can it be changed? Its currently working on switch A in the same manner. And I could use it this way, I would just prefer to not have to mess with other switches. Having it all on my idle up switch would be nice.

[DavidH]

Go into the governor menu in the model menu. Open the governor menu. On the bottom left corner of the screen, you will see the Switch selection. Open it up and assign the switch you want to use there. You can also set where the switch is off or on for each position. One lead from the governor will need to be plugged into Channel 7 to use this feature. Not sure if you can assign RPM's to the revmax thur this function.

David

[Mike J]

Iv'e tried using the governor menu for the Rexmax, and it doesn't work. I followed the setup instructions I found here http://www.modelavionics.com/Jockey/RadioTips/FUTABA_14MZ.htm Only problem was no matter what I set the rate at, I couldn't get the green light to go off when I was above 25% stick. It should be out if its not over 52%.