JR9xii won't work with reflex even after the mod has been do

[norman]

okay then guys this is puzzling i've just brought a new 9x and it won't work at all with the reflex? the sim won't even recognise it it won't even calibrate. Now i've read all these posts its in ppm mode not pcm and i've had the diode mod done to the lead.When i plug the lead into the tx it automatically comes on is that okay do i then still need to move the switch to the on position as well.
I'm very frustrated as i brought this transmitter purposley to practice a few 3d manouveres and it seems all in vain. :arggg:

[Pepacut2]

....its in ppm mode not pcm and i've had the diode mod done to the lead...

I also have a 9x Mkii that I use with Reflex. Ensure that the Swash type is set to 1 servo for your Reflex Model (you have one dedicated, right?) on the TX as reflex does not work with any other swash type.
No Mod to cable was required on my setup.

[Coolice]

Hey,

I to had a lot of trouble getting my JR 9XII to work with Reflex when I first got it, but after some playing around with a soldering iron I managed to do it.

Have you seen here : http://www.reflex-sim.de/reflex-sim/shop/catalog/faqdesk_index.php?faqPath=15_35_71

This denotes the change required to the lead for the 9XII, I cannot remember now if I had to remove the resistor or not now.
If this page doesn't help you ask me and I will remove the heat shrink from my adaptor plug to refresh my memory as to how mines done.
.